Magnetic Motorized Drum HMB
Simple and reliable solution for separating magnetic particles from bulk materials.
Motorized magnetic drums are designed for the continuous separation of foreign magnetic particles from dry granular materials of small granularity. They can be applied wherever there is a risk of damage or undesirable influence on the following technological processes due to the presence of magnetic particles in the base material, or where the separation of magnetic and non-magnetic particles is directly part of the technology. It is a solution suitable for example in the environment of recycling operations, foundries, ceramics, power and fuel, glassworks and others.
The separator operates on the principle of attraction of the magnetic field generated by the ORMAKON high-intensity permanent magnet system stored inside the drum shell.
• Easy installation
• High separation efficiency
• Maintenance-free operation
• High operational reliability
• High magnet magnet system
• 20 years of magnet efficiency guarantee
• Wide range of dimensions
ORMAKON magnets have a non-homogeneous magnetic orientation that concentrates the magnetic flux and significantly increases the maximum magnetic field induction values in the functional pole. In this way, higher efficiency can be achieved than with homogeneously oriented anisotropic magnets.
The material flowing over the belt over the drum shell is exposed to the magnetic field, and the magnetic particles are attracted to the drum by this field. The release of the belt occurs after the point of convergence of the belt from the drum, where the belt pulls the trapped particles out of the magnet magnetic field. The drive magnetic drum is installed in a manner identical to the installation of a conventional conveyor belt drive drum when the drive drum is at the same time disposable and does not require special structural or technological interventions.
The use of these new magnets allows to increase the technical parameters (eg power magnetic effects, power, energy savings, miniaturization) of numerous products and to develop completely new devices and design solutions for which the properties of existing permanent magnets did not suffice.
The values in the table are standardized series. If necessary, drums can also be supplied in other length dimensions and with modified shaft end positions for storage. The drive shaft or drive mechanism is individually tailored to the existing (in case of replacement of the normal drive drum) or to the required drive of the relevant performance and technical parameters.
It is always advisable to consult the HMB magnetic drum in consultation with the supplier.
This project was implemented with financial support from the state budget through the Ministry of Industry and Trade and the partner of the project is SVÚM a.s., Praha - Běchovice.