UHMW PE wear plates for inner walls of transfer and loading points.

The most important features of UHMW PE materials:

- High abrasion resistance

- Low coefficient of friction

- Resists a wide range of chemicals

- Refuses water and does not absorb water

- It is intended for direct contact with food

- Low weight

The inner walls of the tanks and transport of loose and powdery materials should be provided with UHMW PE lining for the following reasons:

- The load bearing structure must be protected from wear and corrosion

- The smooth and slippery surface of the inner walls supports the mass flow through the reservoir

- Low adhesion on the walls of the hoppers allows easy detachment of the material

- Non-sticky properties prevent the build-up of overlapping fins

Benefits of used material

- So steep walls are not required to achieve mass flow as in the case of others contact materials (concrete, structural steel, basalt, glass, etc.)

- Supports easy detachment of the material from the dump walls in a wet condition

- Eliminates the formation of vaults and chimneys

- Prevents accidental rolling over and slipping

- It helps to increase the life of the structure

- Is lighter than most stored materials and therefore does not cause additional loading of the hopper

Sizes

- 2,000 x 1,000 mm

- 3,000 x 1,200 mm

- thicknesses from 6 mm to 40 mm.

Material color: white, green, black.